Wet-Back Fire Tube Heavy Oil Water Boilers

What are the precautions in the loading and installation of gas-fired steam boilers?

Gas-fired steam boilers are a very wide range of special equipments, widely used in food, chemical, paper, textile, construction and other industries. In the process of loading and installing a gas steam boiler, some problems must be paid attention, otherwise it may cause a certain degree of economic loss.

1. Pay attention to the following matters during the loading and unloading and handling of gas-fired boilers: the lifting capacity of the lifting equipment should match the weight of the lifting boiler. The lifting lug on the boiler with the lifting lugs that cannot be used for lifting can not be used for lifting. The length of the steel cord should be reasonably selected to avoid the scratching of the furnace due to the improper length of the steel cord. The boiler must be protected from any damage during handling and handling.

2. Reserves for maintenance space When installing boilers, ensure that there is sufficient maintenance space around the boiler.

3. Setting and precautions for the base and base of the gas steam boiler The boiler body must be installed on the basis of 100-150mm above the floor of the boiler room. It must be confirmed with the technical personnel of the boiler manufacturing company in advance and constructed according to the basic drawings. The anchor bolts must be reserved on the foundation. The foundation shall be capable of withstanding the maximum weight of the boiler and the amount of water it holds. When installing the base, you must first position it. After positioning, adjust to the same length of the two diagonals of the base, and then tighten all the fixing bolts. The installation of the base is carried out with reference to the reference line.

4, general precautions Be careful not to tilt and impact the boiler and accessories too much. No combustibles can be placed around the boiler. Do not use oil and water to smother the boiler. The boiler should normally be installed in a separate boiler room. The new gas-fired boiler room should not be connected to the house. The boiler room shall not be connected to Class A, Class B and Category C fire hazard rooms using flammable liquids. If connected to other production plants, the application firewall is separated.

5. The fire resistance grade and fire protection requirements of the boiler house building shall comply with the requirements of the Code for Fire Protection of Building Design and the Code for Fire Protection Design of High-rise Civil Buildings. The ground of the gas steam boiler room should be flat, non-flammable, no water accumulation, and the foundation load should meet the requirements. The power supply voltage of the gas steam boiler room should be stable to avoid causing the electrical components to burn out. If the voltage is unstable, it is recommended to install a voltage regulator. Ventilation equipment should be installed in the boiler room, and the boiler should be kept at room temperature below 50 °.

Gas steam boiler loading, installation considerations gas steam boiler is a very wide range of special equipment, usually built in the boiler room. However, its load, the installation process, some issues must be taken, otherwise it may cause a certain degree of economic losses. 1, the process of handling and transporting gas in a steam boiler to be noted the following: the lifting capacity of the lifting device should be matched to the weight of the boiler Lifting. Can not be used for lifting has a length marked with a lifting lug can not be used should be chosen on the boiler rope, rope length to avoid inappropriate, leading to scratching furnace. In the loading, unloading and handling process must ensure that the boiler without any damage. 2, installation of boiler maintenance reserve space, make sure there is enough space for maintenance around the boiler. 3, the base gas steam boiler, the base of the boiler and precautions to be installed on the basis of 100-150mm above the floor of the boiler on the premises, subject to prior confirmation boiler manufacturing company with technical personnel, in accordance with the basis for construction drawings. Must stay out of anchor bolts embedded hole basis. Foundation must be able to withstand the weight of the boiler and the largest holding water amount. When the mounting base, must first be positioned. After the alignment adjustment in the end the length of two diagonal lines of the same base, then the entire tightening the fixing bolt. Base mounting reference line marked for reference. 4. General Precautions Be careful not to tilt too boilers and accessories and be impact. Can not be placed outside the boiler fuel. Do not dirty oil and wet-back fire tube water boilerss should generally be installed in a separate boiler room, the new gas steam boiler room should not be connected to the house. A boiler can not be connected, (B) and (C) use of flammable liquid fire risk room. If the production plant is connected to the other, separated by a firewall application. 5, fire resistance rating of the boiler room of the building and fire safety requirements should be consistent with "architectural design code for fire protection" and "design of tall buildings for fire protection" requirements. Gas-fired steam boiler room on the ground should be smooth, non-flammable, no water, load-bearing foundation should meet the requirements. Gas-fired steam boiler supply voltage should be stable, to avoid burn electrical components. The voltage instability, is recommended to install regulators. To set the boiler room ventilation equipment, to maintain the boiler temperature at 50 ° or less.

Horizontal condensing pressure hot wet-back fire tube water boilers Precautions: 1. boiler control system to be used according to the instructions for correct operation. 2. boiler outfall road, drainage pipe must be connected to a sewage ditch. 3. The furnace room layout is reasonable, boiler room should always be kept dry and clean to prevent moisture control system. 4. types of fuel: natural gas, city gas, liquefied petroleum gas, light oil, heavy oil. The temperature should be in accordance with local diesel, heavy oil should be previously heated to 40 ~ 60oC. 6. Power Requirements: rated voltage AC.380V, 50Hz. Voltage fluctuations within the rated voltage range of ± 5%. Boiler installation should the installation protective earth wire. 7. Non placed around the boiler oil, gas and other flammable materials. Tank, the gas tank and the boiler room external wall footing line pitch should be more than 15 meters. When there is a specific reason to shorten the distance fire, it should be the local fire department and the relevant authorities; if using underground arrangement, the cover layer should be more than 0.5m, around the need to increase the firewall; underground, pumping anchor bolts must be tightened or other measures adopted to prevent the displacement of fritters. 8. Horizontal condensing pressure hot water boiler pipe PRECAUTIONS:

General Secretary Xi Jinping fully implement the important instructions on promoting clean northern winter heating, Xi Jinping adhere to the new era of socialist thought and nineteenth spirit of the party with Chinese characteristics as a guide, actively and steadily make 2018--2019 Nian northern clean heating season Heating work to ensure the safety of the masses warm winter, the energy Bureau of Beijing, Tianjin, Hebei, Shanxi, Inner Mongolia, Liaoning, Jilin, Heilongjiang, Shandong, Shaanxi, Gansu, Ningxia, Xinjiang, Qinghai, Henan province (autonomous regions and municipalities) and Xinjiang production construction Corps development and reform Commission (energy Board), Beijing Municipal Administration Commission, nuclear, China Guangdong nuclear power, China petroleum, China petrochemical, China national Offshore oil, national grid, Inner Mongolia electric power, China Huaneng, China Datang, China Huadian, the national energy State power investment Corporation, China Three Gorges, SDIC, China Resources coal, China electric power construction, China can build Group (company), power planning and Design, Water Resources and Hydropower planning and Design and other regions and major companies asked the following notification.

First, a solid grasp of clean heating embodiment implemented. At present, the country has been in accordance with the "Clean northern winter heating plan (2017-2021 years)" (hereinafter referred to as "Plan") requires the preparation of a clean heating embodiment of their respective regions, to develop a clean heating annual work plans.

Second, and steadily push forward the "coal to gas," "coal to electricity." Should adhere to the electric power, the gas should be air, should the coal is coal, the heat should be hot, for a given change, after the first stand break. "Coal to gas," gas will be to change, to implement gas supply further implementation of the transformation. All localities should earnestly fulfill the main responsibility to protect people's livelihood gas, good supply in the region decomposition of the implementation, coordination arrangements, rational use.

Third, actively expand the scale of renewable energy heating. All localities should combine resources, to improve geothermal resources exploration and development efforts under the premise of no damage to the ecological environment, simplifying formalities projects, improve the supporting policies, increased geothermal heating area.

Fourth, push forward clean coal-fired central heating. Coal should adhere to the coal, clean coal-fired central heating expanding area. By localities should give priority to production, as emergency reserves peaking power, improve the heating capacity of the unit, expand heating radius, planning and construction of people's livelihood back-pressure thermal power generating units, etc., to further encourage ultra-low emission cogeneration clean heating. Combined with coal production capacity to deploy a unified, rational part of the release of advanced coal production capacity, protect the livelihood of coal for heating. Greatly enhance the environmental performance of coal-fired boiler room, implementation of the "planning" on the ultra-low emission coal-fired boiler in City requirements.

Fifth, keep the masses warm winter safety bottom line. Around the implementation of clean energy supply in new heating facilities, safe and stable operation before, never allow removal of the original heating facilities. Better use of coal, electricity, natural gas and other energy sources for UNPROFOR, users still need to use coal for heating, a really good job of clean coal supply security work.

Sixth, to explore innovative clean heating mode. To clean around heating combined with practical, innovative institutional mechanisms to optimize the business environment, further liberalization of energy, heat production and supply areas, and guide social capital into clean heating market, encourage enterprises to carry out technological innovation and management innovation, the development of new technologies, new models The new format.

Seven, strengthen supervision clean heating work. According to "planning" urged all localities to innovative regulatory measures and means to closely follow the progress of work, mastery goal of task completion and work to promote the practical difficulties, in conjunction with the Energy Bureau sent regulators to organize the supervision and inspection and appraisal. All localities must submit the plan to the Energy Board by December 15 to submit the report within two weeks after the end of the heating season.